OPS and OTS

Functional specification

The following functions have been specified:

FR.R1

Amplification

FR.R2

Separation/combination of power supply and signal

Environmental conditions

The following environmental conditions have been specified:

EC.R1

Description: Minimum temperature

Value : -25

Units : Celsius

Test method: Climate chamber temperature setting

EC.R2

Description: Maximum temperature

Value : 70

Units : Celsius

Test method: Climate chamber temperature setting

Cost factors

The following cost factors have been specified:

CF.R1

Description: Maximum supply voltage

Value : 10

Units : V

Test method: Power supply setting during test

CF.R2

Description: Maximum power dissipation

Value : 0.25

Units : W

Test method: Measure current consumption from power supply and calculate the power

CF.R3

Description: PCA max length

Value : 50

Units : mm

Test method: Measure with ruler

CF.R4

Description: PCA max width

Value : 25

Units : mm

Test method: Measure with ruler

CF.R5

Description: PCA max height

Value : 15

Units : mm

Test method: Measure with ruler

CF.R6

Description: Antenna length

Value : 0.5

Units : m

Test method: Measure with ruler

Performance requirements

The following performance requirements have been specified:

PR.R1

Description: Source impedance

Value : 6.427e-12

Units : F

Test method: Not tested

PR.R2

Description: Max. RMS value source voltage

Value : 0.225

Units : V

Test method: Setting test generator

PR.R3

Description: Min. -3dB signal frequency

Value : 100000

Units : Hz

Test method: Setting test generator

PR.R4

Description: Max. -3dB signal frequency

Value : 30000000

Units : Hz

Test method: Setting test generator

PR.R5

Description: Source-to-load voltage transfer

Value : 1

Units : -

Test method: Measure with network analyzer and capacitive source

PR.R6

Description: Output impedance

Value : 50

Units : Ohm

Test method: Measure with network analyzer

PR.R7

Description: Load impedance

Value : 50

Units : Ohm

Test method: Use 50 Ohm termination

PR.R8

Description: Source-referred noise spectrum floor

Value : 2.5e-17

Units : V^2/Hz

Test method: Spectrum analyser (with input amplifier) 50 Ohm termination

PR.R9

Description: Source-referred noise spectrum F^-2

Value : 1.0e-6/F^2

Units : V^2/Hz

Test method: Spectrum analyser (with input amplifier) 50 Ohm termination

PR.R10

Description: Peak-to-peak load voltage drive capability (at max current)

Value : 0.6364

Units : V

Test method: Oscilloscope, use 50 Ohm termination

PR.R11

Description: Peak-to-peak load current drive capability (at max voltage)

Value : 0.012728

Units : A

Test method: Oscilloscope, use 50 Ohm termination

PR.R12

Description: Load voltage slew rate

Value : 59978919.6651

Units : V/s

Test method: Oscilloscope, use 50 Ohm termination